Protan adhered warm roof system on timber substrate

Protan AB

Protan adhered warm roof system on timber substrate

PROTAN ADHERED WARM ROOF SYSTEM ON TIMBER SUBSTRATE

The Protan Adhered System can be used on both warm and cold roof structures, new build and renovation projects. In some countries adhesion is a common roofing method, but this solution cannot be installed during cold or wet weather.

This type of solution can be appropriate on buildings with high humidity, such as swimming pools, and on roofs with, for example, a wood wool deck, where mechanical fastening is difficult.

For fully adhered roofing systems, Protan has developed the Protan EX-A membrane with polyester fleece on the reverse.

CONSTRUCTION STRUCTURE:

PROTAN EX-A MEMBRANE
MEMBRANE ADHESIVE
INSULATION
INSULATION ADHESIVE OR INSULATION FASTENERS
VAPOUR CONTROL LAYER
TIMBER SUBSTRATE

PROTAN EX-A MEMBRANE:

Protan EX-A membrane is a polyester reinforced PVC membrane which has a polyester fleece laminated on the reverse side. The membrane is to be installed in an exposed adhered roof system in which it is bonded to polyisocyanurate (PIR) or suitable mineral wool insulation, please contact Protan for approved insulation types.

MEMBRANE ADHESIVE:

Protan ProBond moisture curing PU adhesive or approved moisture curing PU adhesive.

SYSTEM INSTALLATION METHOD:

Protan Adhered Roof System - It is required that the roofing membrane is fully adhered (i.e. 100% covered with adhesive). Any insulation must be fastened to the roof structure separately to resist wind forces. This can be achieved by either adhering the insulation to a load bearing surface or mechanically fastening it to the structure. It is critical that there is good 'anchoring' between all the layers in the roof structure.

Please contact Protan for further advice.

INSULATION:

Various types of insulation can be used in combination with Protan membranes and can be flat insulation or sloped insulation. The material type and design will depend on the building design, fire classification and local regulation requirements.

Mineral wool (MW) – can be glass or stone type - glass tissue faced
Polyisocyanurate (PIR) - glass tissue faced

INSULATION ADHESIVE:

Protan Insulation adhesive or approved insulation manufacturer adhesive

VAPOUR CONTROL LAYER:

Polyethylene - only use when mechanically fastening the insulation
Bitumen

TIMBER SUBSTRATE:

OSB manufactured to EN 300 grade OSB/3 or as required by local regulations. Minimum 18mm in thickness or as approved by the fastener manufacturer.
Plywood manufactured to EN 1995-1-1 Eurocode 5. Minimum 18mm in thickness or as approved by the fastener manufacturer.
Timber boarding. Minimum 23mm in thickness or as approved by the fastener manufacturer.

Detaljer
Product family: Roofing	Product group: Single Ply Membrane
Main material: PVC	Designed in: Norway
Manufactured in: Norway	Publishing date: 19 februari 2019
Installation instruction	Product certification
Technical description	Product page